Philips RQ1087/21 User Manual page 18

English
20
cleaning fluid level is too low. Clean the shaver thoroughly before you
continue shaving. If necessary, clean and refill the cleaning chamber
(see chapter 'Cleaning and maintenance').
- The shaving heads may be damaged or worn. Replace the shaving
unit (see chapter 'Replacement').
2 Why doesn't the shaver work when I press the on/off button?
- The battery may be empty. Recharge the battery (see chapter
'Charging').
- The travel lock may be activated. Press the on/off button for 3
seconds to deactivate the travel lock.
- The shaving unit is soiled or damaged to such an extent that the
motor cannot run. In this case, the shaving unit symbol, the tap
symbol and the exclamation mark flash. When this happens, you have
to clean the shaving unit or replace it.
- The temperature of the shaver may be too high. In this case, the
shaver does not work and the exclamation mark on the display
flashes. As soon as the temperature of the shaver has dropped
sufficiently, you can switch on the shaver again.
 Why isn't the shaver entirely clean after I cleaned it in the Jet Clean
System?
- The cleaning fluid in the cleaning chamber may be soiled. Empty and
rinse the cleaning chamber.
- The cleaning fluid level may be too low. If the fluid volume in the
cleaning chamber drops below the minimum level during the cleaning
program, the program aborts.The cleaning light and the
'cleaning chamber empty' symbol flash at intervals and the holder
returns to its starting position. Refill the cleaning chamber with
cleaning fluid up to the MAX indication (see chapter 'Cleaning and
maintenance').
- You may have used another cleaning fluid than the original Philips
cleaning fluid. Only use HQ200 cleaning fluid.
 Why doesn't the Jet Clean System work when I press the on/off
button?