5
Fill the cleaning chamber with HQ200 cleaning fluid up to the MAX
indication (Fig. 1).
6
Place the Jet Clean System back onto the cleaning
chamber (Fig. 2).
Make sure the release buttons click back into place.
using the Jet Clean system
1
Place the shaver in the holder.
The display shows that the shaver is charging (see chapter 'The
,
display') (Fig. ).
2
Press the on/off button on the Jet Clean System to start the
cleaning program. (Fig. )
The shaver display stops showing the charging indication.
,
The cleaning light starts to flash and the shaver is automatically
,
lowered into the cleaning fluid (Fig. 35).
The cleaning light flashes throughout the cleaning program, which
,
takes to 6 minutes, depending on the cleaning program.
During the first phase of the cleaning program, the shaver
,
automatically switches on and off several times and moves up and
down.
During the second phase of the cleaning program, the shaver is
,
placed in the drying position, indicated by a flashing drying symbol.
This phase takes approx. 2 hours. The shaver stays in this position
until the end of the program. (Fig. 6)
After the cleaning program, the charging indication appears on the
,
shaver display (see chapter 'The display').
Note: If you press the on/off button of the Jet Clean System during the
cleaning program, the program aborts and resets. In this case, the cleaning or
drying light stops flashing and the holder returns to its starting position.
Note: If you remove the adapter from the wall socket during the cleaning
program, the program aborts. The holder remains in its current position. When
you put the adapter back into the wall socket, the holder moves to the
highest position.
English
15