2-Port 100-Gigabit Ethernet Modular Port Adapter With Cfp2 - Cisco ASR 9000 Series Installation Manual

2-Port 100-Gigabit Ethernet Modular Port Adapter with CFP2

Port LED State
Red
Green
Blinking Green and Amber
Caution Plugging a non-supported CPAK to a CFP2 adapter can damage the CFP2 adapter. Ensure that you read the
PID label on the CFP2 adapter carefully.
Caution
It is strongly recommended to wait for 60 seconds before successive insertion or removal of optics. Failure
in following this recommendation may affect the functionality of optics.
Caution The metal surfaces of CPF2-DCO modules may exhibit high temperature and can be unsafe for handling with
bare hands. Hot surface warning label is provided on the faceplate of the MPA where the optical module is
inserted.
For more information about how to remove the CFP2-DCO module, see
on page
2-Port 100-Gigabit Ethernet Modular Port Adapter with CFP2
The 2-Port 100-Gigabit Ethernet (GE) modular port adapter (MPA) supports LAN/WAN/OTN mode and
provides two cages of coherent transceiver CFP2 modules that operate at a rate of 100 Gbps.
The 2-Port 100GE MPA is supported on both bay 0 and bay 1 of 400 Gigabit Modular Line Card
(A9K-MOD400-SE, A9K-MOD400-TR, A9K-MOD400-CM) and on bay 0 of the 200-Gigabit Line Card
(A9K-MOD200-SE, A9K-MOD200-TR).
This MPA supports 10X10 and 2X40 breakout configuration.
Cisco ASR 9000 Series Aggregation Services Router Ethernet Line Card Installation Guide
50
Status
100G interface is in down state.
100G interface is in up state.
100G interface is up and carrying traffic.
87.
Overview
Safe Removal of CFP2-DCO Modules,