Table of Contents
Advertisement
Setting the sound options
To set the sound options, press the Mode button once to place the controller into 'voice' mode. Use
the up and down buttons to select one of the desired audible settings as follows:
•
High
•
Medium
•
Low
•
Off (sound off mutes all voice prompts and audible tones)
Press the Mode button twice to return to normal operation. If no buttons are pressed for
approximately ten seconds the controller will return to normal operation.
Setting the clock
The clock is a 12-hour AM/PM style display.
To set the time, press the Mode button twice, this places the controller into 'clock setting' mode and
in the digital display the word Clock will be displayed and the clock digits will flash.
Use the up or down buttons to select the time, holding these buttons down continuously cycles the
digits. When you get close to the time you wish to set, press the button intermittently to avoid going
further than the desired time.
To return to normal operation, press the Mode button once. If no buttons are pressed for
approximately 60 seconds the controller will return to normal operation.
The time is always displayed regardless of whether the controller is turned on or off.
The clock may need resetting if power to the water heater is disrupted due to a power failure or if
the power is switched off over a prolonged period. The default time is set to AM 12:00.
Rinnai INFINITY Deluxe controller OIM 01-20 | 9
Advertisement
Table of Contents
