Table of Contents
Advertisement
55 °C maximum
Temperatures higher than 55 °C should not
be able to be selected on controllers installed
in bathrooms, ensuites, or toilets. This is to
reduce the risk of burns from hot water. If this
is not the case, the controllers have been
incorrectly installed and you should contact
your installer.
Bath
Avoid water in the speaker
Avoid getting water directly into the speaker
(circled in images above) as this may cause
damage.
Controllers need to be turned on for delivery of hot water
The water heater will not heat the water unless the controller(s) are turned on. If water is flowing
before the controller is turned on, the water heater will not heat the water. Turn off the tap for a few
seconds, then turn on again.
Ignition problems
If the water heater fails to ignite, the In Use button will not illuminate. The water heater will not
attempt re-ignition until water flow is stopped for a few seconds and then re-started.
When gas bottles have been changed or the gas supply is disrupted (controller may display error
code 11 or 12) ignition may fail and the In Use button will not illuminate. The water flow may need
to be stopped and re-started several times to get the water heater to work.
Always check before use
Check the water temperature before use.
A parent or carer should ALWAYS check
the temperature before a child is placed in
contact with hot water.
Rinnai INFINITY Deluxe controller OIM 01-20 | 7
Advertisement
Table of Contents
