Table of Contents
Advertisement
Illuminated On/Off and Transfer buttons confirm that the desired controller is in control of the water
delivery temperature. If the On/Off button is not illuminated, press the Transfer button once, the
On/Off and Transfer buttons will illuminate indicating that the hot water temperature control has
been transferred and that the hot water unit will be ready to supply hot water once a hot water tap
is opened.
Setting the sound options
To set the sound options, press the Mode button once to place the controller into 'voice' mode. Use
the up and down buttons to select one of the desired audible settings as follows:
•
High
•
Medium
•
Low
•
Off (sound off mutes all voice prompts and audible tones)
Press the Mode button twice to return to normal operation. If no buttons are pressed for
approximately ten seconds the controller will return to normal operation.
Setting the clock
The clock is a 12-hour AM/PM style display.
To set the time, press the Mode button twice, this places the controller into 'clock setting' mode and
in the digital display the word Clock will be displayed and the clock digits will flash.
Use the up or down buttons to select the time, holding these buttons down continuously cycles the
digits. When you get close to the time you wish to set, press the button intermittently to avoid going
further than the desired time.
To return to normal operation, press the Mode button once. If no buttons are pressed for
approximately 60 seconds the controller will return to normal operation.
The time is always displayed regardless of whether the controller is turned on or off.
The clock may need resetting if power to the water heater is disrupted due to a power failure or if
the power is switched off over a prolonged period. The default time is set to AM 12:00.
Setting shower saver / bath fill
This function allows a preset water volume and temperature to be selected and run automatically.
Default settings:
•
Temperature
•
Volume
Press the Shower Saver / Bath Fill button once. The button will illuminate and the voice prompt and
tone will sound. Ensure you have the voice and sound turned on.
To select the temperature use the Temperature up and down buttons. The selected temperature
will be displayed on the monitor and will remain as the default temperature until it is changed.
When filling a bath for the first time, it is recommended that a low bath fill volume such as 60 L or
lower be used. During subsequent bath fills the volume can be adjusted.
A volume counter, to highlight the remaining volume of water to be delivered, displays on the
controller below the temperature display, replacing the clock when the shower saver / bath fill
function is on.
= 40 °C
= 100 L (range 30-400 L)
Rinnai INFINITY Deluxe controller OIM 01-20 | 11
Advertisement
Table of Contents
