Assembly; Connecting Power Sensor/Monitor - Omron EQUO Series User Manual

3.3

Assembly

3.3.1 Connecting Power Sensor/Monitor

(1) Power Sensor/Monitor Settings (KM Series)
Communication protocol
Unit No.
Communication Speed
Data Bit Length
Stop Bit Length
Vertical Parity
Transmission Waiting Time
*1 KM20-B40-FLK and KM100 are not included.
*2 The initial values of KM-N2-FLK and KM-N3-FLK are set to Modbus.
*3 The initial values of KM-N2-FLK and KM-N3-FLK are set to 8 bits.
*4 The initial values of KM-N2-FLK and KM-N3-FLK are set to 1 bit.
■Individual Power Sensor/Monitor Type Setting
[1] The first unit only requires the following setting if its factory settings have not been
changed.
<KM50->
Power ON → (Meas. Mode) → (Setting Mode) → (Comm. Setting Mode)
→ (Comm. Speed Setting) → Set to "38.4"
Twice
<KM20-B40-FLK>
Turn ON the DIP switches 2 and 3 (COMMUNICATION SETTING SW). (See below)
<KM100>
Power ON → (Operation Level) → (Setting Level) → (Comm. Setting Level)
→ (Comm. Speed Setting) → Set to "38.4"
KMX21
*1
Compoway/F
Assign unique consecutive numbers.
38.4 kbps
7 bit (Factory default)
2 bit (Factory default)
EVEN (Factory default)
20 ms (Factory default)
Hold the key
Hold the key
Twice
3-2
3. Check and Preparation
*2
*3
*4
Unit No.: 01
To Change
To Apply
To Change
To Apply