Tool Holder, Attachments; Working With The Power Tool - Festool CXS Original Operating Manual

LED green - flashing quickly
Charging battery pack at
maximum rate.
LED green - flashing slowly
Charging battery pack to 80%
and with reduced current.
LED green - lit continuously
Charging process is charged.
LED red - flashing
General fault indicator, e.g.
incomplete contact, short
circuit, defective battery
pack, etc.
LED red - lit continuously
Battery temperature is
outside permissible limit
values (0 °C to 55 °C).
7 Settings
CAUTION
Risk of injury
Always switch off the power tool before
adjusting settings!
7.1 Changing direction of rotation [1-5]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Changing gear [1-4]
• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
7.3 Adjust torque [1-2]
The marking [1-3] shows the selected position.
Drilling
Marking shows the drill symbol [1-1] = Maximum
torque.
Fastening
Torque corresponding to setting:
Position 1 = low torque
Position 12 = high torque
8

Tool holder, attachments

WARNING
Risk of injury
Always disconnect the battery pack before
performing any type of work on the machine.
CAUTION
Hot and sharp tool
Risk of injury
Do not use insert tools that are blunt or
defective!
Wear protective gloves.
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under "www.festool.com".
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks!
8.2 Chuck BF-FX10 [5]
For clamping drill bits and bits with max. shaft
diameter of 10 mm.
Clamp tool centrally in the chuck.
8.3 Angle attachment XS-AS [6] (accessories)
Drilling and screwdriving at right angle to power
tool.
You can engage the angle attachment in
16 different angle settings.
8.4 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.
9

Working with the power tool

WARNING
Risk of injury
Always secure the workpiece in such a manner
that it cannot move while being machined.
9.1 ON/OFF switch [1-6]
Press = ON, release = OFF
The speed of the machine depends on how
far the ON/OFF switch is pressed in.
9.2 LED lamp with capacity indicator
The LED bulb [1-11] lights up when the ON/OFF
switch is pressed [1-6].
After releasing the ON/OFF switch [1-6] the ca-
pacity indicator on the LED lamp [1-11] displays
the state of charge of the battery pack for a few
seconds:
CXS
17