Tool Holder, Attachments; Working With The Machine; Service And Maintenance; Environment - Festool C 18 Li Original Operating Manual

9

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp tool
► Do not use any blunt or faulty tools.
► Wear protective gloves.
9.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
9.2 Chuck BF-FX
For clamping drill bits and bits with max. shaft
diameter of 13 mm.
Clamp tool centrally in the chuck.
9.3 Angle attachment DD-AS [6]
Drilling and screwing at right angle to machine
(partly as an accessory).
9.4 Eccentric attachment DD-ES [7]
Screwdriving near edges with bits according to
ISO 1173 (partly as accessory).
9.5 Tool holder in the drill spindle [8]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.

10 Working with the machine

WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
10.1 Bit depot [1-2]
Magnetic, for storing bits and bit holders.
10.2 Acoustic warning signals
Acoustic warning signals sound and the ma­
chine switches off in the following operating
states:
Battery flat or machine over­
loaded.
–
–
Machine is overheating.
–
LiIon battery pack is faulty or
has overheated.
–

11 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs
must only be carried out by the
manufacturer or service work­
shops. Find the nearest address
at: www.festool.co.uk/service
Always use original Festool
EKAT
4 spare parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
Keep the contacts on the power tool, charger
and battery pack clean.

12 Environment

Do not dispose of the device in the
household waste!Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
Change the battery.
Place the machine under
reduced stress.
You must allow the ma­
chine to cool beforeusing
again.
Once the battery pack has
cooled, perform a func­
tional check using the
charger.
English
15