Table of Contents
Advertisement
◆
Registering ID codes
Every tire pressure warning valve and transmitter has a unique ID code.
When replacing a tire pressure warning valve and transmitter, it is necessary
to register the ID code.
When registering the ID codes, perform the following procedure.
Park the vehicle in a safe place, wait for approximately 20 minutes, and
1
then start the engine. (P. 187)
Press
2
Press
3
Settings", and then press
Press
4
then press
Press
5
control switches and select
"Change Wheel Set", and then
press and hold
pressure warning light starts
slowly blinking 3 times.
Then a message will be displayed on
the multi-information display.
When registration is being performed, the tire pressure warning light will blink for
approximately 1 minute then illuminate and "--" will be displayed for the inflation
pressure of each tire on the multi-information display.
Drive at approximately 40 km/h (25 mph) or more for approximately 10 to
6
30 minutes.
Registration is complete when the tire pressure warning light turns off and the
inflation pressure of each tire is displayed on the multi-information display.
Even if the vehicle is not driven at approximately 40 km/h (25 mph) or more, reg-
istration can be completed by driving for a long time. However, if registration does
not complete after driving for 1 hour or more, perform the procedure again from
the beginning.
Initialize the tire pressure warning system. (P. 506)
7
GX460_OM_OM60R28E_(GE)
or
of the meter control switches and select
or
of the meter control switches and select "Vehicle
.
or
of the meter control switches and select "TPWS", and
.
or
of the meter
until the tire
6-3. Do-it-yourself maintenance
507
.
6
Advertisement
Table of Contents
