Igniter Replacement; Baffle Removal & Replace - Quadra-Fire PS35-C Owner's Manual

E. Igniter Replacement
1. Shut down the appliance by turning down the
thermostat and let the appliance completely cool down.
After the appliance has cooled down, unplug it and
remove the ash drawer.
2. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
3. Follow section on Side Curtain Replacement on
page 24 to remove right side curtain from the appliance
to expose the spade connectors.
4. Disconnect the spade connectors and remove the
igniter from the chamber. Loosen thumb screw and
slide igniter out.
5. Install new igniter into the chamber and tighten thumb
screw. The wires MUST route through the wire retainer
hook and then re-connect the wires to the 2 leads with
the spade connectors (Figure 26.1).
6. Double check that the igniter wires are clear of any
movement, i.e. ash drawer, firepot cleaning rod, etc.
7. Re-install the ash drawer and side panel and
re-connect the power.
Firepot
Igniter
Chamber
Igniter
Thumb
Screw
Through Wire Retainer Hook
Figure 26.1
26
Thermocouple &
Thermocouple Cover
Firepot Cleaning Rod
Igniter Wires
MUST BE ROUTED
F. Baffle Removal & Replace
1. Shut down the appliance by turning down the
thermostat and let the appliance completely cool down.
2. Remove the center baffle first by using the handle at
the top of the baffle and pull up and then towards you.
The hooks on the baffle will slide out of the slots in the
bracket (Figure 26.2).
3. Remove the left baffle and then the right baffle
by pulling up and then towards you. The left
and right baffles have similar hooks and slots
(Figures 26.3 and 26.4).
4. Re-install the baffles in reverse order. Be careful to
insert the hooks in their respective slots. Be sure the
baffles are completely secure/seated (close, if not
touching, the firebox floor).
Figure 26.2
Remove left baffle
Figure 26.3
Remove right baffle
Figure 26.4
7058-805F
Use handle at top
of center baffle to
pull up and then
towards you.
Lift up to
remove hooks
from slots
Lift up to remove
hooks from slots
04/21