Table of Contents
Advertisement
Firmware Versioning
When performing an update, first download firmware to the receiver, and then update transmitters to the same
firmware version to ensure consistent operation.
The firmware numbering for Shure devices uses the following format: MAJOR.MINOR.PATCH (e.g., 1.2.14). At a
minimum, all devices on the network (including transmitters), must have the same MAJOR and MINOR firmware
version numbers (e.g., 1.2.x).
Updating the Transmitter
1. Download the firmware to the receiver.
2. Access the following menu from the receiver:
3. Align the IR ports between the transmitter and the receiver. IR ports must be aligned for the entire download,
which can take 50 seconds or longer.
Tip: The red alignment LED will turn on when the alignment is correct.
4. Press ENTER on the receiver to begin the download to the transmitter. The receiver will display the progress of
the update as a percentage.
Wearing the Bodypack Transmitter
Clip the transmitter to a belt or slide a guitar strap through the transmitter clip as shown.
For best results, the belt should be pressed against the base of the clip.
Tip: The clip can removed and rotated 180 degrees to increase mounting options.
RF Mute
RF Mute prevents transmission of the audio by suppressing the RF signal, while allowing the transmitter to remain
powered-on. The home screen displays RF MUTED in this mode.
Device Configuration
>
.
Tx Firmware Update
Shure Incorporated
14/24
Advertisement
Table of Contents
