Operation - MULTIQUIP WHITEMAN Series Operation Manual

NOTICE
DO NOT engage the seat switch by sitting in the
operator's seat. The blades will not turn if an operator
is in the seat while the drive bypass switch is pressed.
In drive bypass mode, the rotors are only turned via
drive bypass rocker switch and foot pedal engagement.
3. With the blades slowly spinning, use the forklift to
slowly lift the trowel until all trowel blades are clear
of the concrete pad surface. REMEMBER to keep all
personnel out of the area between the forklift and the
trowel.
4. Release the drive bypass switch and foot pedal, and
stand clear of the forklift and trowel.
ENGINE SHUTDOWN
1. On the left side of the engine speed rocker switch
(turtle), press down until the engine is at idle (Figure
32). Let engine idle for 3-5 minutes.
ENGINE SPEED
ROCKER
SWITCH
IDLE
SPEED
(TURTLE)
Figure 32. Engine Shutdown
NOTICE
Failure to allow the engine to idle for 5 minutes before
shutting engine OFF may lead to damage.
2. Turn the ignition key counterclockwise to the OFF
position then remove the key.
HTXG6DF RIDE-ON TROWEL • OPERATION MANUAL —REV. #3 (08/30/19) — PAGE 39
FULL
SPEED
(RABBIT)
ENGINE SPEED
ROCKER
SWITCH
3. If LPG mode was in use, turn shut off valve knob
clockwise to CLOSE (Figure 33).
Figure 33. Propane Tank Shut-Off Valve (Closed)
4. Clean and remove any foreign debris from the trowel.

OPERATION