Avaya S8300 Manual page 8

8 Job Aid: Replacing the S8300 Media Server or its Hard Drive
9
If necessary, upgrade the media server software on the new hardware:
10
Configure the S8300 and restore data. Do either
11
If the new hardware has a later software release than the original hardware, check to see if you
need to upgrade the G700 firmware as described in
12
Install any software patches required.
13
Check for and resolve any new alarms.
14
Test as appropriate — for example, make station and trunk calls.
15
Save translations. If the S8300 on which you replaced the hardware is configured as an LSP, save
translations on the primary controller, not the LSP.
16
Disable FTP on the S8300:
555-245-753
Comcode 700292956
Issue 1
a
If the software release installed on the new hardware is earlier than the release on the
original hardware, upgrade the software on the new hardware to match the release on the
original hardware.
b
If the software release on the original hardware is unknown, and the software on the new
hardware is not the latest bug-fix load, upgrade the software on the new hardware to the
latest bug-fix load.
a
If the original hardware is functional or if the software release installed on the original
hardware is the same as or later than the release installed on the new hardware, then:
— Configure the network data (Host Name, IP address, subnet mask, default gateway
IP address).
— Restore all data
b
If the original hardware is not functional and the software release installed on the original
hardware is either unknown or earlier than the release installed on the new hardware,
then:
— Configure the S8300 as you would a new install using either the Avaya Installation
Wizard and the Pre-Installation Worksheet previously created, or using the
Maintenance Web Interface.
— Restore only the translations and the Audix announcements
a
On the Maintenance Web Interface, select Enable/Disable Anonymous FTP under the
"Security heading
b
Click on Disable
Step a or Step b:
Step 8 in the Before you go to the site section.