Avaya S8300 Manual page 7

f
Detach the hard-drive ribbon cable from the hard drive (leave cable attached to the S8300
circuit pack).
g
Unpack and install the new hard drive on the S8300. Standoffs for the new hard drive
should be included in the new hard drive package.
NOTE:
If standoffs are not included with the new hard drive, remove the standoffs from the old drive and
reuse them. Before screwing the standoffs into the new hard drive, clean the threads thoroughly
with a damp cloth or paper towel.
h
Screw the standoffs into the new hard drive.
CAUTION:
In Step i, be careful not to bend the pins on the hard drive. Leave the four jumper pins to the right of
the ribbon cable open and unconnected, as shown in
i
Connect the open end of the hard-drive ribbon cable (which is attached to the S8300
circuit pack) to the replacement hard drive, as shown in
to the end of the ribbon connector marked with the red stripe.
j
Place the hard drive on the S8300 circuit pack with the standoffs aligned with the screw
holes.
k
Hold the S8300 circuit pack on its side, with the hard drive in place, and screw the four
screws through the bottom of the S8300 circuit pack into the hard-drive standoffs.
l
If you are replacing the S8300 circuit pack, and if the CWY1 board is installed on the
original S8300, remove the CWY1 board from the original S8300 and install it on the new
S8300 circuit pack.
m
Insert the S8300 into slot V1 of the G700. The LED panel (above slot V1) must be
removed and reinserted together with the S8300 circuit pack. Insert both the LED panel
and S8300 circuit pack about 1/3 of the way into the guides (the guides are in slot V1 for
the S8300 and above slot V1 for the LED panel). Push both circuit packs (together) back
into the guides, gently and firmly, until the front of each circuit pack aligns with the front
of the G700.
n
Secure the S8300 faceplate with the thumb screws. Tighten the thumb screws with a screw
driver.
5
Power up the G700 by plugging in the G700 power cord.
6
Connect your laptop to the Services port on the S8300 and access the Maintenance Web Interface.
7
Enable FTP on the S8300:
a
On the Maintenance Web Interface, select Enable/Disable Anonymous FTP under the
"Security heading
b
Click on Enable
8
Install the license and authentication files.
Job Aid: Replacing the S8300 Media Server or its Hard Drive
Figure 1.
Figure 1. Connect pin number one
555-245-753
Comcode 700292956
Issue 1
7