Xerox Telecopier 7033 Service Manual page 78

25. Remove paper output roller #2 pulley/bearing. (PL 5.5)
a. Open upper scanner assembly.
b. Remove belt from pulley.
c. Remove E-ring from front end of shaft.
e. Loosen set screw in pulley (Figure 18), and remove pulley.
f. Remove pulley, and if necessary, remove the bearing by sliding
off of shaft.
Set screw
Bearing
Figure 18. Pulley and bearing removal
26. Remove paper output roller #2. (PL 5.5)
a. Remove six securing screws from electrical box assembly, and
slide the left end far enough from the terminal to enable
access to gears and belts at the left end.
Telecopier 7032 / 7033 Service Manual
Belt
Pulley
b. Remove E-ring and bearing from rear end of shaft (Figure 19).
Bearing
Paper output roller
Figure 19. Paper output roller removal
c. To remove shaft from terminal, push shaft forward from the
rear until shaft end clears frame and remove.
7033-245
8/91
www.printcopy.info
4-20
4.3 Lower Scanner Assembly
7033-246