Xerox Telecopier 7033 Service Manual page 76

20. Remove upper paper chute assembly. (PL 5.4A)
a. Disconnect plugs from ADF document and scan position
sensors (P151 and P150).
b. Remove four screws from paper chute assembly (Figure 14).
P151
P150
P153
Figure 14. Upper paper chute assembly removal
c. Carefully lift top chute assembly out of the terminal until the
area #3 jam sensor assembly can be accessed, and disconnect
P153 from sensor.
Telecopier 7032 / 7033 Service Manual
21. Remove area #3 jam sensor. (PL 5.4A)
a. Using a small screwdriver, gently push on clip (Figure 15) to
release sensor.
7033-242
8/91
www.printcopy.info
4-18
Clip
Figure 15. Sensor removal
4.3 Lower Scanner Assembly
7033-241