Xerox Telecopier 7033 Service Manual page 262

1.2 Installation
1.2.1 7032/7033 Security Lock Kit
1. Remove Printer Cover assembly from carton and verify contents.
• Printer Cover Assembly with Lock
• Two keys
• Kit Installation Instructions
2. Remove the following components.
a. Disconnect the power cord.
b. Remove the Printer cover assembly (PL 5.1A).
c. Lower the right side cover.
d. Open the printer top cover.
e. Loosen the four top cover screws.
f. Partially close the upper printer, and remove the cover.
left end must be lifted up first, and then slide the cover away
from upper printer hinge shaft.
3. Install the following components.
a. Remove the two keys secured with tape from the underside of
the cover.
b. Install the cover with the security lock in reverse order making
sure the security lock cam is parallel with the top cover as seen
through the cut-out (Figure 1).
c. Install the Imaging Cartridge into the terminal, close the cover
and secure the security lock with key. Make sure the cover is
secure and can not be opened.
1.2, 1.2.1
d. Perform a diagnostic self test and copy operation.
e. Instruct the customer on the use of the Security Lock Option
and give the customer the two keys.
Cut-out
The
6/92
www.printcopy.info
8g-2
Document Guides
Locking
Cam
Security Lock
Figure 1. Printer Cover Assembly
Top View
Telecopier 7032 / 7033 Service Manual