ADC 410F User Manual page 58

Configuring the LAN and WAN

For the
Information Protocol) activated in
information on RIP.
‘
For the
transmissions in
on RIP.
’
Enter the
LAN segments or IP addresses not in its routing table.
“
Enter the
LAN segments or IP addresses not in its routing table.
5 Enter the DHCP configuration parameters:
DHCP can be enabled only when routing is enabled. If you select DHCP Enable
when routing is not enabled, the modem deselects DHCP Enable when you
click Submit. If you disable routing, the modem deselects DHCP Enable when
you click Submit.
”
Select DHCP Enable
assign IP addresses to devices on the LAN. If you select DHCP, ensure that all
devices on the LAN have the TCP/IP stack set to
(see "Setting Up the PC to Access the Modem Web Pages" on page
The modem automatically enters the
as one address higher than the Ethernet port on the modem with DHCP enabled.
You cannot edit this field.
Enter an IP address for a device that will provide
human-readable machine names into IP addresses.
Enter an IP address for a device that will provide
human-readable machine names into IP addresses (optional).
The modem enters a default
Ethernet 10/100BASE-T port of the modem. You can edit this field.
6 Click Submit
7 Some parameter changes are not permanent until you write them to NVRAM and do not
take effect until you reset the modem. See
Effecting Changes" on page
50
LAN and WAN RIP Direction
LAN and WAN RIP Version
mode. See
Routing
LAN Default Gateway Address
LAN Default Gateway Mask
to enable the modem to act as a DHCP server to automatically
Gateway
to accept the Brouter LAN-WAN configuration.
36.
, select the direction you want RIP (Routing
Routing mode. See "Routing" on page 71
, select the version of RIP used for intergateway
"Routing" on page 71
(IP address) for the modem to access other
(subnet IP mask) for the modem to access other
:
obtain an IP address automatically
for the first device on the LAN
Start IP Address
Primary DNS
Secondary DNS
IP address, which is the same IP address as the
"Saving the Configuration and
Megabit Modem 410F and 420F User Manual
for more
for more information
27).
. DNS translates
. DNS translates