ADC 410F User Manual page 34

Using the RS-232 management Port for Set Up
(9) Type
(Routing Information Protocol) activated in routing mode. Select enabled to
activate both RIP directions (incoming and outgoing) in routing mode. Select
disabled to not activate RIP.
(10) Type
(Routing Information Protocol) activated in routing mode. Select enabled to
activate both RIP directions (incoming and outgoing) in routing mode. Select
disabled to not activate RIP.
(11) Type
other LAN segments or IP addresses not in its routing table.
(12) Type
the modem may forward packets) for a device on the LAN or WAN that will
manage the modem. To allow any device on the LAN or WAN to manage
the modem, enter 0.0.0.0. For more information, see
Admin IP Address" on page
(13) Type
This returns all parameters to the default values, not only the subset of
parameters that you can configure using the Megabit Modem Setup Menu. For
more information, see
When you type 13 then enter y to return to factory default values, the modem
automatically resets.
(14) Type
IP address and the IP network mask. You must reset the modem to effect these
changes.
26
9 then enter y to toggle LAN RIP to select the direction you want RIP
then enter y to toggle WAN RIP to select the direction you want RIP
1 0
1 1 then enter the default gateway IP address for the modem to access
1 2 then enter the IP address (which is the address of the router to which
1 3 then enter y to return the parameters to the factory default values.
"Resetting the Modem to Factory Defaults" on page
1 4 then enter y to reset the modem after you change the WAN and LAN
46.
Megabit Modem 410F and 420F User Manual
"Configuring the
39.