Chapter 5. Technical Specifications; Rrs11 And Rrs11 L Technical Specifications; Introduction - Rrs11 L-Band Switch; General Specifications - Comtech EF Data RADYNE RRS11 Installation And Operation Manual

Chapter 5.
5.1

RRS11 and RRS11 L Technical Specifications

5.2

Introduction - RRS11 L-Band Switch

This section defines the technical performance parameters and specifications for the Solid-State
Transfer Switch. The RRS11L is intended to operate with the DM240-PIIC or DM240XR
modulators.

5.2.1 General Specifications

RRS11-L L-Band Configuration:
Switch Time:
Rear Panel Ports:
Front Panel Ports:
Control Ports:
Status Port:
Return Loss:
MN-RRS11
Rev. 3
Technical
Specifications
DM240-PIIC OR DM240XR only
50 msec Maximum
L-Band input: J7 - SMA, 50 ohm (mod A)
L-Band input: J8 – SMA, 50 ohm (mod B)
L-Band output: J6 – N-type, 50 ohm (online)
L-Band output: J9 – N-type, 50 ohm (offline)
L-Band Monitor input: J4 - SMA, 50 ohm (Mod A)
L-Band Monitor input: J5: - SMA, 50 ohm (Mod B)
L-Band Monitor output: BNC 50 ohm (Mod A)
L-Band Monitor output: BNC 50 ohm (Mod B)
L-Band Monitor output (online)
L-Band Monitor output (offline)
DB-9 Male: J2 (prime)
DB-9 Male: J3 (backup)
SMA: 14 dB (L-band input)
N-Type: 14dB (L-band output)
5–1