Oetiker Clamp Servicing; Oetiker Clamp Chart - BRP Evinrude E-TEC G2 150 HP Installation & Predelivery Manual

Next, bundle the components that route to the out-
board with a rigging hoses such as P/N 770392,
or P/N 770393, or other flexible conduit.
Rigging Hose Installation

Oetiker Clamp Servicing

WARNING
DO NOT re-use Oetiker clamps. Fuel leakage
could contribute to a fire or explosion.
Clamp Identification
Use Oetiker clamps for making hose connections.
These clamps provide corrosion resistance, mini-
mize the potential for abrasion of rigging compo-
nents, and provide solid, permanent connections.
The selection and installation of an Oetiker clamp
is essential in the proper sealing of hose connec-
tions.
The clamp identification numbers appear on the
side of the clamp, near the top of the ear. Refer to
Oetiker Clamp Chart on p. 43 chart for clamp
dimensions.
1
1. Clamp identification numbers
Clamp Selection
To select the correct size Oetiker clamp, measure
the outside diameter of the hose when installed on
the fitting.
Chose a clamp so that the outside diameter of the
hose is approximately in the middle of the clamp-
ing range of the clamp.
Refer to Oetiker Clamp Chart on p. 43.
Clamp Installation
A constant stress should be applied to close the
ear clamps. This method ensures a positive stress
on the hose and does not result in excessive com-
009094
pression or expansion of the band material.
IMPORTANT:
tools to close Oetiker stepless clamps.
Oetiker pincers are available in the Evinrude Gen-
uine Parts and Accessories Catalog.
•
Position correct size clamp over hose.
•
Install hose on fitting.
000093
Boat Rigging
Cable and Hose Installation
Use only Oetiker recommended
1
2
DP0886
41