JETWAY NF9T Series Technical Manual page 48

IGD Boot Type
Use this item to select preference display interface used when system boot.
The optional settings are: [Auto]; [CRT]; [HDMI]; [LVDS].
* Note: User needs to set 'Active LFP' as [Enabled], otherwise the optional setting
[LVDS] will not be available.
Active LFP
The optional settings are: [Disabled]; [Enabled].
[Disable]: VBIOS disable LVDS.
[Enable]: VBIOS enable LVDS.
* Note: When set as 'Enabled', user can make further settings in 'LVDS Panel
Type'.
* LVDS Panel Type select by JP2 jumper. Check Page.14~16 for detail
information.
 South Bridge
Press [Enter] to set south bridge parameters.
 Azalia HD Audio
Press [Enter] to further Azalia HD Audio options.
Audio Configuration
Audio Controller
The optional settings are: [Disabled]; [Enabled]
Azalia HDMI Codec
Use this item to enable or disable internal HDMI codec for Azalia.
The optional settings are: [Disabled]; [Enabled].
 USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
USB 3.0 Support
The optional settings are: [Enabled]; [Disabled]; [Auto]; [Smart Auto].
* Note: When set as [Disable], USB 2.0 Support is applicable, for user to make
further settings.
43