JETWAY NF9T Series Technical Manual page 46

Use this item to set USB mass storage device start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. 'Auto' uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].
Select [Manual] you can set value for the following sub-item: 'Device Power-up
delay in seconds'.
Device Power-up delay in seconds
The delay range is from 1 to 40 seconds, in one second increments.
 Intel(R) 82583V Gigabit Network Connection (XX:XX:XX:XX...)
Use this item to get driver information and configure gigabit ethernet device
parameter.
Press [Enter] to make settings for the following sub-items:
PORT CONFIGURATION MENU
 NIC Configuration
Press [Enter] to make settings for the following sub-items:
Link Speed
Use this item to specifies the port speed used for the selected boot protocol.
The optional settings are: [Auto Negotiated]; [10 Mbps Half]; [10 Mbps Full];
[100 Mbps Half]; [100 Mbps Full].
Wake On LAN
The optional settings are: [Disabled]; [Enabled].
Use this item to enable the server to be powered on using an in-band magic
packet.
Blink LEDs
This item help to indentify the physical network port by blinking the associated
LED.
Port CONFIGURATION INFORMATION
This is for user to have a view of the list of current LAN port configuration
41