Removing And Installing The Hard Disk - Siemens SIMATIC Box PC 820 Manual

1.3.11

Removing and Installing the Hard Disk

S
If you are using the Box PC 820, remove the floppy disk/CD-ROM drive support
as described in Section 1.3.9.
S
If you are using the PC FI45 V2, lower the floppy disk/CD-ROM drive support to
one side of the housing as described in Section 1.3.10.
S
Remove the four screws with which the hard disk support is fastened to the
housing.
S
Remove the disk drive connecting cables and lift the support carefully out of the
housing.
S
Remove the four screws with which the hard disk is fastened to the
vibration-damped part of the support.
S
Take the hard disk out out of the support.
To install the drive, proceed in reverse order.
Figure 1-17 Removing the Hard Disk Support
Siemens Distributor
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
Fastening screws for
hard disk support
Hard disk support
Fastening screws for
hard disk support
System Unit
1-23