Philips DVDR75/051 Operating Instructions Manual page 72

Programming a recording (TIMER)
6
The decoded data appears after confirmation. You can go back and
change the data. Select the appropriate input field with C or D . If
required, make changes using CH+ A , CH- B or the number
buttons 0..9 .
' input field using C . Using SELECT switch on 'VPS/PDC'
Select the '
(' ' lights up). If you press SELECT again, you will switch 'VPS/PDC' off (' '
goes out).
' input field using C .
Select the '
Use SELECT to select the recording mode '
7
If all information is correct, press the OK button. The programming
information is stored in a TIMER block.
8
To end, press TIMER .
9
Insert a recordable disc (one without write protection).
The disk you have inserted will be checked.
0
Switch the DVD recorder off with STANDBY m .
The programmed recording will only function properly if the DVD
recorder has been
If any of the TIMER blocks are in use, '
1
Switch on the TV set. If required, select the programme number for
the DVD recorder.
2
Press TIMER on the remote control.
The programming method selected last is marked.
3
Select line '
confirm with the C button.
The information will appear on the screen.
4
Select the input field with D or C .
5
Enter information with CH- B or CH+ A or with the number
buttons 0..9 .
, , , , ,
using the STANDBY m button.
' will light up on the recorder display.
' with CH- B or CH+ A . and
'.