Philips DVDR75/051 Operating Instructions Manual page 21

8
After the data transfer has been completed,, the following appears on
the screen: '
a
Normally the date and time are taken from the data sent by the TV
channel stored on programme P01. If th aerial signal is too weak or there
is excessive interference, you should set the date and time manually:
1
Check if the time in '
2
If required, change the time with the number buttons 0..9 on your
remote control.
3
Select the next line with CH+ A or CH- B .
4
Check if the displayed settings for '
correct.
5
When all information is correct, save by pressing OK .
a
Not all the necessary data has been transferred. Please enter the settings
by hand as follows. For more information on the various functions see
'Initial installation' in 'Installing your DVD recorder'.
1
Select the desired audio language using CH- B or CH+ A and confirm
with OK .
2
Select the desired subtitle language with
confirm with OK .
3
Select the desired screen format position using CH- B or CH+ A .
' '
' '
' ' For a 16:9 TV set
4
Confirm with OK .
Initial installation is now complete.
Have the following cables ready:
an aerial cable (1, supplied), a mains cable (2, supplied), a scart cable (3).
1
Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN socket at the back of the DVD recorder.
'.
' is correct.
', '
CH- B or
For a 4:3 TV set; cinema format (black bars above and
below the picture)
For a 4:3 TV set; full height format with the sides cut
off
Connecting the DVD recorder
' and ' ' are
CH+ A and