Philips DVDR75/051 Operating Instructions Manual page 30

Installing your DVD recorder
7
Select the desired screen format position using CH- B or CH+ A .
These settings will only be used if you insert a DVD that contains this
information.
' ' for a 'wide-screen' (cinema format) picture with black bars at
the top and bottom.
' ' for a full-height picture with the sides trimmed.
' ' for a wide-screen TV set (screen edge ratio 16:9)
8
Confirm with OK .
9
Select the country of your residence with CH- B or CH+ A .
If your country does not appear, select '
To call up the specific settings for the respective country, you must first install
the country.
0
Confirm with OK .
A
After you connect the aerial (or cable TV, satellite receiver, etc.) to
the DVD recorder, press OK .
'Autoinstall' starts. '
appears on the screen:
a
b Select channel 1 on the TV set. Can you see the stored TV channel on the
TV set?
If not, check the cable connection from the aerial (aerial socket) to the
DVD recorder and to the TV set.
b Please have patience.
The DVD recorder searches the entire frequency range in order to find
and save the largest possible number of TV channels.
b If you have not connected an aerial, go through all the basic settings right
to the end and then, if you wish, start the automatic search (see next
chapter 'Automatic TV programme search (Autoinstall)').
B
Wait until all available TV channels have been found. This can take
several minutes.
C
When AUTOINSTALL is complete, '
briefly appear on the TV screen.
À
To end, press SYSTEM-MENU .
The initial installation is now complete.
Check the date and time. Please read 'Setting the time and date' in this chapter.
'.
' will appear on the display. The following
' will