Name A Radio Preset; View Radio Data System (Rds) - Philips HTR9900/12 User Manual

Note
•
One can store the same channel in two preset
locations - one with "FM STEREO ON" and another
with "FM STEREO OFF".

Name a radio preset

You can assign an eight character 'User Name'
to each radio preset, which will show in the
front-panel readout whenever that preset is
recalled.
1
Recall the desired radio preset.
2
Then, press and hold INFO until the
display shows a fl ashing cursor point.
3
Use the front panel vV buttons to select
the fi rst character of the name ('N' from
the alphabetical list).
4
Press front panel B button to select the
character and correspondingly move
forward to the next position.
(Press b to go back to the previous
character). Repeat this process for each
character in sequence.
5
Press the MEMORY/PROGRAM button
again to store the name and exit the text
entry mode.
EN
26

View Radio Data System (RDS)

The Radio Data System (RDS) permits sending
small amounts of digital information using
conventional FM radio broadcasts. The High
Defi nition A/V Receiver supports two RDS
modes, station-name (PS mode) and radio-text
(RT mode). Not every FM station incorporates
RDS in its broadcast signal. In most areas you
will fi nd from one to several RDS-enabled
stations, but it is by no means impossible that
your favorite stations will not be broadcasting
RDS data.
View RDS texts
When an RDS-enabled FM broadcast is tuned,
after a brief delay the 'RDS' symbol will
illuminate in the High Defi nition A/V Receiver's
front-panel readout and the readout's character
section will show its station-name (PS) text:
'ROCK101', for example.
Press the INFO button on the remote control
to toggle the readout between this and the
station's radio-text (RT) readout, if any, which
might scroll song- or artist name, or any other
text of the station's choosing.