Video Setup - Philips HTR9900/12 User Manual

[Tone controls]
Listening mode
Audio synchs
Tone controls
Settings menu
Pure Tone allows you vary or completely
bypass the tone control section of the High
Defi nition A/V Receiver.
[Off] is selected, the Tone Control
• If
circuits are active. Select [On] to bypass
the Tone Controls effectively defeating the
effect of the tone control circuits.
The High Defi nition A/V Receiver has two
Tone Control levels - [Treble] and [Bass].
• Bass and Treble controls only affect the
low bass and high treble leaving the critical
midrange frequencies free of colouration.
These controls allow one to tweak
on-the-fl y, the frequency response of the
source. Use the vV buttons to adjust
Treble and Bass within the range ± 10 dB
EN
34
Pure tone : Off
Treble : 0dB
Bass : 0dB

Video setup

Settings menu
Source setup
Speaker setup
Trigger setup
Listening Mode setup
Video setup
Language setup
[Picture setup]
Picture setup
Video modes
Brightness
Contrast
Color
MPEG Noise reduction : Off
Cross Color suppresor
Film Mode detection
Picture setup can be defaulted to [Normal] or
[Custom]. While at [Video modes] menu item,
select [Normal] to retain the default picture
setup settings. If you would like to further
improve the picture settings or adjust the
parametres according to your preference, set
[Video modes] to [Custom]. The following
parametres can be adjusted.
• [Brightness]
– Adjust overall brightness of
the picture.
• [Contrast] – Adjust bright areas (white
level) of the picture.
• [Color]
– If brightness and contrast levels
are set optimally, adjust the colour control
to the level of your preference.
• [MPEG Noise reduction]
designed to address two specifi c types of
video distortion - mosquito noise and
blocking artifacts. Set the level to High,
Medium or Low.
Picture setup
: Custom
: 50
: 50
: 50
: Off
: Off
– This setting is