Table of Contents
Advertisement
2. Configure the eNB to connect to the Baicells CloudCore:
a. Go to the BTS Settings > Management Server menu (Figure 3-10).
b. Enter baiomc.cloudapp.net:48080/smallcell/AcsService as the management
server.
c. Enter your unique CloudKey that was provided by Baicells. The CloudKey is
operator-specific and enables devices, upon power up, to be added
automatically to your OMC account.
Figure 3-10: Management Server
3. Configure the network interfaces. Go to the Network > WAN/LAN menu (Figure 3-11).
a. WAN
i. Ensure the Interface name is set to WAN.
ii. Enter one or more Domain Name Server (DNS) IP addresses.
iii. Set the Connect Type to either Copper or Fiber, per your backhaul
network.
iv. The eNB can use one of 3 connection services: DHCP, PPPoE, or Static IP,
as described below. Choose a Connect Via option for this eNB.
•
•
•
b. LAN - The LAN address is the same one used to access the eNB GUI:
192.168.150.1. The subnet mask is 255.255.255.0.
Dynamic Host Configuration Protocol (DHCP) – The eNB's IP address
will be obtained dynamically from the local DHCP server. The
current DHCP server IP address will be displayed, along with the
link speed. When DHCP is selected as the connection method, there
are no further WAN fields to configure in this window.
Point-to-Point Protocol Over Ethernet (PPPoE) – not recommended.
If PPPoE is selected, you will be prompted to enter the user name
and password. The range of each is 1 to 100 digits. You can also
enter an access controller name and service name.
Static IP – IPv4 address, netmask, and gateway or IP address of the
Domain Name Server (DNS), where multiple addresses are allowed.
17
Advertisement
Table of Contents
