Remove Knockouts - Chamberlain MyQ Business CAPXL Installation Manual

INTRODUCTION
1

Remove Knockouts

1. Turn the key clockwise to unlock the CAPXL.
INTRODUCTION
2. Open the door and lay the CAPXL face down on
a table with the door hanging off the edge of the
table as shown.
3. Identify which knockouts need to be removed
based on your application.
INTRODUCTION
4. Use a center punch tool to remove the knockouts
from the outside of the box inward using an
appropriately sized punch and hammer. NOTE:
Be careful when removing the knockouts to avoid
damaging the CAPXL components.
W S
R
R
E = Electrical Wiring
P = Pedestal Mount
R = Recess Mount
S = Security+ 2.0
W = Wi-Fi
PRE-INSTALL
PRE-INSTALL
PRE-INSTALL
S W
R
P P
E
P P
R
®
Radio Antenna
Antenna
®
INSTALL
To prevent damage to the CAPXL from moisture or water:
INSTALL
• DO NOT install during rain. Internal components MUST be
kept free from of water and moisture.
• BEFORE opening the front cover of the CAPXL, remove ANY
accumulated water from the top of the CAPXL.
To prevent damage to ANY internal components:
• DO NOT attempt to remove the knockouts with a hammer.
INSTALL Banging on the knockouts may result in shock to the circuit
boards, which could cause permanent damage.
W
S
11
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
E
E
E