Unloading From A Vehicle Or Loading Dock - Powermate Aluminum LE Series Operating Manual

UNLOADING FROM A VEHICLE OR LOADING DOCK

1. Place the equipment in a safe well balanced position with the load carriage
between the heelplate and the main frame wheels.
2. Locate the equipment at the edge of the vehicle/loading dock with the
heelplate overhanging and clear of the edge. Set the main frame wheels.
3. Jog the left hand pushbutton thumb switch "Load Down" to partially lower
the heelplate.
4. Jog the right side of the center rocker switch "Load Up" to raise the load
carriage to a more balanced position ahead of the main frame wheels. (See
Diagram "D")
5. Alternate between steps #3 & 4 to lower the heelplate to the ground out
from the rear of the vehicle or the base of the dock. (See Diagram "C") This
will provide clearance for the main frame wheels when they are lowered.
6. Push the left side of the center rocker switch "Load Down" to lower the load
carriage to the ground. (See Diagram "B")
7. Pivot the equipment forward on the heelplate just enough to clear the main
frame wheels.
8. Push the right hand pushbutton thumb switch "Load Up" to lower the main
frame wheels. (See Diagram "A")
Place the equipment in a safe well balanced position with the load carriage
9.
between the heelplate and the main frame wheels.
PowerMate
3.05
®
Operation Manual
PN 013330 Rev.D2
Eng. 12/ 12/ 12