Le-Series Powermate Charging Instruction - Powermate Aluminum LE Series Operating Manual

Small Slot Terminal
Center Hole
Large Slot Terminal
Wall Charger
400210

LE-SERIES POWERMATE CHARGING INSTRUCTION

Center Prong
TWIST LOCK
PLUG
FLANGE TWIST
LOCK RECEPTACLE
INSTRUCTION:
In-Vehicle
Electronic
Charger
400215/6
Control Toggle Switch
Small Tang Terminal
Large Tang Terminal
Circuit Breaker Pedal
Circuit Breaker Toggle
1. Provide electrical power to the Battery Charger being used.
®
2. De-activate the PowerMate by depressing the Circuit Breaker Pedal located on top
of the Battery Box, moving the Circuit Breaker Toggle to the down (off) position.
Move the Control Toggle Switch to the "O"(off) position.
3. Insert the Charger Twist Lock Plug into the Charging Receptacle located in the
Handle Housing. The Plug will lock in place with a slight clockwise turn.
The charge cycle is fully automatic. The Wall Charger and the In-vehicle Electronic
Charger will indicate the charge status by LED indicators. Refer to the specific
Charger documentation.
4. To discontinue the charge cycle, dis-engage the Charger Plug from the Receptacle
by using a slight counter clockwise turn and pull.
®
5. The PowerMate can be re-activated for use by moving the Circuit Breaker Toggle
to the on (up) position and moving the Control Toggle Switch to the "I"(On) position.
®
NOTE: The PowerMate can remain on the Battery Charger at all times, ensuring a
fully charged unit when called upon. In any case, the Circuit Breaker Toggle
should always be in the off (down) position when the PowerMate
3.01
®
PowerMate Operation Manual
Battery Box
®
is not in use.
PN 013360 Rev.D2
Eng. 12/ 12/ 12