Toro Z Master Professional 5000 Series Operator's Manual page 46

Removing the Battery
WARNING
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses
to explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
WARNING
Incorrect battery cable routing could damage
the machine and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the battery as shown in
Figure 60
Installing the Battery
Note:
posts opposite from the hydraulic tank
Charging the Battery
Charging the battery produces gasses that
can explode.
-
EUTRAL LOCK
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
(1.265 specific gravity). This is especially
Figure 60.
important to prevent battery damage when the
temperature is below 0°C (32°F).
1.
2.
3.
g027728
46
Position the battery in the tray with the terminal
Figure 61
WARNING
Always keep the battery fully charged
Charge battery for 10 to 15 minutes at 25 to 30
A or 30 minutes at 10 A.
When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 62).
Install the battery in the machine and connect
the battery cables; refer to
(page 46).
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
(Figure 60).
g032526
Installing the Battery