3 3 . . 1 1 0 0 . . 2 2 R R e e m m o o v v i i n n g g / / C C l l e e a a n n i i n n g g R R e e s s e e r r v v o o i i r r
Open door and pull reservoir forward.
1 1 ) )
Slide reservoir to the left and lift from fryer. See
2 2 ) )
From Unit , page
21.
Figure 3-8 Removing Reservoir From Unit
Clean reservoir at a sink with soap and water.
3 3 ) )
I I N N F F O O : Before placing the reservoir back into position, lubricate the O-rings (below) on
the filter tube with cold oil. Check O-rings for tears or nicks and replace if necessary.
To replace O-ring, use a small, flat-bladed screwdriver, pry upon the O-ring and pull
off of end of tube. See
Figure 3-9 Replacing O-Ring , page
Figure 3-7 Reservoir Fill Line
Figure 3-8 Removing Reservoir
22.
21