Regency Grandview G800EC Series Manual page 18

Venting Arrangements - Horizontal Termination
Rigid pipe and FPI direct vent system (flex)
(Propane & Natural Gas)
The diagram shows all allowable combinations of vertical runs with horizontal terminations, using one 90
Note: Must use optional rigid pipe adaptor (Part # 510-994) when using Rigid Pipe venting systems.
0
18
16
14
12
10
8
6
4
2
0
•
Maintain clearances to combustibles.
• Horizontal vent must be supported every 3 feet.
• Firestops are required at each floor level and whenever passing through a wall.
Horizontal (Feet)
4
2 6
Set #1 (2" open)
No Restrictor
44" (1118mm)
Minimum
Height
Requirement
8
10 12
Note: FPI Direct Vent Flex System Part
elbow (two 45 elbows equal one 90
o o
14 16
18
All Rigid Pipe Systems
4" inner diameter
6-5/8" outer diameter
FPI Flex Vent
4" inner diameter
6-7/8" inner diameter
A vent guard should be used
whenever the termination is lower
than the specified minimum or as
per local codes.
#:946-513 (2 foot), 946-515 (4 foot)
and 946-516 (10 foot) are only ap-
proved for horizontal terminations.
Grandview® G800EC Gas Fireplace | P. 18
elbow).
o
20