A Few Precautions; When Using The Stylus Scan - Epson STYLUS SCAN 2500 User Manual

If you use an extension cord with the Stylus Scan, make sure
the total amperage of the devices plugged into the extension
cord does not exceed the cord's ampere rating. Also, make
sure the total ampere rating of all devices plugged into the
wall outlet does not exceed the wall outlet's ampere rating.
Do not attempt to service the Stylus Scan yourself.
Unplug the Stylus Scan and refer servicing to qualified service
personnel under any of the following conditions:
The power cord or plug is damaged; liquid has entered the
Stylus Scan; the Stylus Scan has been dropped or the cabinet
damaged; the Stylus Scan does not operate normally or
exhibits a distinct change in performance.
To provide adequate short-circuit protection and over-
current protection for this Stylus Scan, the building
installation must be protected by a 16 Amp circuit breaker.

A Few Precautions

When using the Stylus Scan

Do not put your hand inside the Stylus Scan or touch the ink
cartridges during operation.
Do not move the print head by hand. Doing so may damage
the Stylus Scan.
Always use the
When this button is pressed, the Operate light flashes briefly
then goes off. Do not unplug the Stylus Scan or turn off the
power to the outlet until the Operate light stops flashing. The
scanner carriage must be secured with the Transportation
Lock.
power button to turn off the Stylus Scan.
P
Safety Instructions
2-3