Threading The Upper Looper - Husqvarna Viking Amber Air S 400 User Manual

Threading the Upper Looper

Turn off the main power switch and unplug the machine.
Note: Raise the presser foot lifter for easier threading.
Place a thread spool on the second right spool pin. Pull the
thread through the second right thread guide from back to
front (A).
Note: If the thread tends to slip away from the guide while sewing,
pass the thread through both thread guide holes as shown (B).
Slide the thread under the top cover thread guide (C) as il-
lustrated.
Pull the thread along the threading slit. Using both hands,
insert the thread between the disks (D).
Set the lower looper pre-tension setting slider (E) to
NORM.
Pull the thread down along the slit and into the upper loop-
er thread guide (F).
Pull out approximately 12˝ (30 cm) of thread. Make sure
that the thread does not get tangled around the lever or the
cover.
16 – GETTING READY TO SEW
L
M
A
C
E
A
B
C
D
E
F
J
I
K
G
B
D
F
H