Securing The Thread Chain; Tie A Knot; Use A Sewing Needle; Use The Machine At The Start Of A Seam - Husqvarna Viking Amber Air S 400 User Manual

Securing the Thread Chain

Tie a Knot (A)
To avoid the thread chain from ravelling, separate and tie the
thread ends together.
Use a Sewing Needle (B)
1. Thread the chain into a large eyed, hand sewing needle.
2. Insert the needle into the end of the seam and pull the
chain into the seam to secure the threads.
Use the Machine at the Start of a Seam (C)
1. Before placing the fabric in the machine, sew a thread
chain approximately 2"-3" (5-8cm) long.
2. Place your fabric in front of the presser foot. Sew a few
stitches and stop.
3. Raise the presser foot and bring the thread chain to the
left around and under the presser foot.
4. Place the thread chain between the presser foot and upper
knife, holding it in position as you lower the presser foot
to sew.
5. After sewing approximately 1˝ (2.5 cm), move the chain to
the right and under the upper knife, cutting the chain as
you sew.
Use the Machine at the End of a Seam (D)
1. Serge one stitch off the end of the seam.
2. Raise the needle and presser foot, and gently pull the
threads off the stitch finger.
3. Turn the fabric over so that the under side is up.
4. Serge approximately 1˝ (2.5cm) over the stitching and an-
gle off the fabric.

Cutting the Seams Open

Cut the upper looper thread with a seam ripper (not included
with the machine) to cut the seams.
A
C
D
B
SEWING – 33