Connecting The Foot Control And The Power Supply; Before Using Your Machine For The First Time; Setting Up The Telescopic Thread Stand - Husqvarna Viking Amber Air S 400 User Manual

Connecting the Foot Control
and the Power Supply
Foot control to use with this machine:
Type C-1028 for USA/Canada, C-2085-1 for U.K., C-2065 for
Australia, C-2060 for Continental Europe.
Before plugging your machine in, make sure the voltage is the
same as indicated on the lower rear side of the machine. Speci-
fications vary from country to country.
• Connect the foot control/electric power cord to the socket
on the machine (A).
• Plug the power cord plug into the electric outlet (B).
• Push the power switch (C) to "I" to turn on the machine.
• Press the foot control to start sewing (D). Use the foot
control to adjust the sewing speed. The harder you press,
the faster the machine will sew.
• To stop the machine from sewing, remove your foot from
the control.
• Push the power switch to "0" to turn off the machine.
Note: When the front cover and/or the flat bed extension cover is/are
opened, the safety switch is activated and prevents the machine from sew-
ing, even if the foot control is pressed. The machine will also be prevented
from sewing when the foot is raised.
Note: Your overlock machine is adjusted to provide the best stitch result at
normal room temperature. Extreme hot and cold temperatures can affect
the sewn result.
Before Using Your Machine
for the First Time
Before using your machine for the first time, place a scrap of
fabric under the presser foot and run the machine without
thread for a few minutes. Wipe away any oil which may appear.

Setting Up the Telescopic Thread Stand

Extend the telescopic thread stand to its full height, then turn
until it clicks into place.
If the machine is already threaded, straighten the threads to
prevent tangling.
C
D
POLARIZED PLUG INFORMATION
(FOR U.S.A. & CANADA ONLY)
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug
is intended to fit in a polarized outlet only way. If the plug
does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.
A B
ABOUT YOUR MACHINE – 7