Removing The Rear Cover; Removing The Seat Cushion - Panasonic EP-MA03 Service Manual

9.2.

Removing the Rear Cover

1. Pull the tips of the fasteners sewn into the inside of the
lower part of the back cover (two each on right and left)
onto the outside.
2. Cut the cable ties on the tips of the fasteners, and pull the
fasteners (two each on right and left) upwards to open.
3. Remove the J-shaped hooks (two each on right and left),
and roll up the back cover so that the rear cover is visible.
Caution:
• A gap will appear on the joins between the rear cover
and the backboard on the top surface and two sides.
This is not a fault.
4. Remove the screws (3 top, 2 bottom) attaching the back
cover in place, and pull the cover forwards, taking care of
one hook as you do so.
9.3.

Removing the Seat Cushion

1. Remove the armrests (see 9.1).
2. Remove the J-shaped hooks (two each on right and left).
3. Place the Ottoman on top of the stand, and pull in the
direction of the arrow.
4. Remove two Brushclips (left-hand side) attached to the
Ottoman and the seat cushion.
5. Pull the fasteners (left-hand side) connecting the Ottoman
and the seat cushion to the outside, and cut the cable
ties. Then open the fasteners.
Caution:
• During assembly, feed the tips of the fasteners through
the rubber holes. (Fix the tip of the left-hand fastener in
place with a cable tie).
35