4.8 SETTING THE SETPOINT 1 DEADBAND
Note
Refer to Table 6-1 for a summary list of menu configuration.
Setpoint 1 Deadband S1.DB is not active unless your meter has dual relay output
capabilities. The LED's will display whether the S1.DB is active or not. The Setpoint 1
Default deadband is 0003. To change the deadband (hysteresis) of Setpoint 1, follow
these steps:
Press the MENU button until the meter shows S1.DB .
1.
Press the ∂TARE button. The meter shows the last previously stored 4-digit
2.
number (0000 through 9999) with flashing 4th digit.
Press the ßMAX button to change the value of the flashing digit. If you continue to
3.
press the ßMAX button, the flashing digit's value continues to change.
Press the ∂TARE button to scroll to the next digit.
4.
5.
Press the MENU button to store your selection. The meter momentarily shows
STRD , followed by S2.DB (Setpoint 2 Deadband).
4.9 SETTING THE SETPOINT 2 DEADBAND
Note
Refer to Table 6-1 for a summary list of menu configuration.
Setpoint 2 Deadband S2.DB is not active unless your meter has dual relay output
capabilities. The LED's will display whether the S2.DB is active or not. The Setpoint 2
default deadband is 0003. To change the deadband (hysteresis) of Setpoint 2, follow
these steps:
Press the MENU button until the meter shows S2.DB .
1.
Press the ∂TARE button. The meter shows the last previously stored 4-digit
2.
number (0000 through 9999) with flashing 4th digit.
Press the ßMAX button to change the value of the flashing digit. If you continue to
3.
press the ßMAX button, the flashing digit's value continues to change.
Press the ∂TARE button to scroll to the next digit.
4.
5.
Press the MENU button to store your selection. The meter momentarily shows
STRD , followed by OT.CF (Output Configuration) if you have analog output
capabilities.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Configuring The Meter
S1.DB
S2.DB
4
33