Table of Contents
Advertisement
Operation using the Virtual Remote Control
You can have remote control operations using the mouse of a PC.
Setting up the Virtual Remote Control
If the remote control screen is starting up, begin the
setup after the screen has finished displaying.
1 Click "Setup Menu" on the Main Menu.
2 Click on the "Setup for Virtual Remote Control"
button.
A setup screen for the remote control will appear.
3 Change the setting to desired operation that is
done through a mouse to suit your needs.
4 Click "Save".
Notes
• Enter under "Threshold value of a scroll wheel" the number
of rotations of the wheel when you are using a mouse.
• In "Customization Menu for the Virtual Remote Control", set
the recorder's operation for each mouse usage time.
• The Virtual Remote Control requires the installation of Java
VM v. 1.5 (1.4.2 for Mac OS X). To check the Java version
which is available, click on the "Confirmation of Java
software version" button in the lower right of the screen.
Using the Virtual Remote Control
Operate the mouse within the frame of the remote-
control screen.
Operate by using the mouse pointer within this
frame. If you click outside of this frame, the device
will not operate.
The recorder will operate according to the setup of the
Virtual Remote Control.
Note
• If you setup the Virtual Remote Control while the display of
the remote control screen is activated, you will need to
restart the remote control screen and then operate the
Virtual Remote Control.
Turning the recorder on/off by the Virtual
Remote Control
Click the power button of the Virtual Remote Control.
The indicator of the button shows the recorder status.
(on: green, off: red)
Note
• If the recorder's power is turned off on the recorder, any
Network Navi operation opens the Main Menu, on which
only the power button is available.
159
Advertisement
Table of Contents
