Gconnecting To A Video Monitor; Connecting To A Video Monitor - Toshiba IK-WR01A Operation Manual

Connecting to a Video Monitor

Connecting to a Video Monitor
You can view camera images on the video monitor.
Rear
24V AC UL Listed Class 2 power supply / 12V DC power supply
CAUTION : Never input AC/DC and PoE at the same time. It may cause a
malfunction of the camera. Ensure that the PoE/POWER SELECT
switch is properly set before inputting power.
In case of DC12V, connect "+12" to red cable and "GND" to black cable.
Since this camera uses 24V AC UL Listed Class 2 power supply or 12V DC power
supply, it should be connected to a power supply that allows for at least 5w
consumption. Because the IK-WR01A uses a mechanism, a sufficient power supply
with adequate current specifications is required.
Important
Power plugs of connected equipment must be disconnected before installation.
G
A 75-ohm coaxial cable (3C-2V or 5C-2V) is required for standard connection.
G
For details of wiring and operation of equipment to be connected, refer to their
G
operation manuals.
Coaxial cables for video signals, LAN cable and the power cord are not supplied with
G
the camera.
Do not connect AC24V and DC12V at the same time. It may cause a malfunction of
G
the camera or AC adapter.
Use a 4 pair twisted cable for the LAN cable to connect the camera to a PoE
G
compatible hub.
Use IEEE802.3af-compliant PoE devices.
G
An AC adapter is not supplied with the network camera. When using an AC adapter,
G
a 10 watt or greater AC adapter is required.
The camera takes about 30 seconds to start after the power is turned on.
G
14
LAN cable
AC24V or DC12V
On the power supply, use a PoE compatible hub, or connect
•
AC24V or DC12V power plug.
Do not overload power supply
Video Monitor
PoE
Either