Steering Wheel; Tyre Pressure - Stiga PARK Series Installation Manual

GB
to the strip covering the valves, the battery
should be replaced.
Position the battery in the appropriate place under
the engine casing, secure with the battery belt and
connect the battery cables (fig. 5).
NOTE! To avoid damage to the engine and the bat-
tery, the positive battery cable (+) should always
be connected to the battery first.
Do not run the engine when the battery is dis-
connected.
SEAT
Install the seat on the seat bracket (fig. 6).
In the rear holes, the screws K should be used
along with the shoulder washers F. Tighten the
screws.
Then place the wing nuts H with the two screws G
and washers I in the front holes.
The seat can be moved backwards or forwards.
Place the seat in the desired position and then tight-
en the wing nuts properly.
The seat can be folded. If the machine is parked
outside when it is raining, fold the seat forward to
protect the seat cushion from getting wet.
The seat is locked. To fold the seat up or down,
first lift up the catch S (fig. 6).

STEERING WHEEL

In order to compensate for any axial play, the shim
washers D and/or E should be used.
First check whether and if so how many shim
washers are required.
Then install the steering wheel by knocking in the
tension pin C (fig. 7).
GEAR LEVER (Compact)
Screw the gear lever M into the threaded hole by
the steering wheel. Grip using an adjustable
wrench, for example, and tighten firmly (fig. 8).
DRAWING PLATE
Screw the drawing plate J into the two holes on the
joist using the screws K and nuts L (fig. 9). Tight-
en the screws properly.

TYRE PRESSURE

Check the air pressure in the tyres. Correct air
pressure:
14
ENGLISH
Front: 0.6 bar (9 psi), Rear: 0.4 bar (6 psi)
ACCESSORIES
For the installation of accessories, see separate in-
stallation guide supplied with each accessory.