CompuLab fitlet2 FC-USB Installation Instructions
Hide thumbs
Also See for fitlet2 FC-USB:
- Owner's manual (17 pages) ,
- Installation instructions (5 pages) ,
- Installation manual (2 pages)
Related Manuals for CompuLab fitlet2 FC-USB
Summary of Contents for CompuLab fitlet2 FC-USB
- Page 1 05.DEC.18 fitlet2 FC-USB installation instructions Package Content 2x 2x 6mm 1x 3pin 1x FC- retaining Phillips power Washer screw cable 1x side panel Plug the 3pin power cable to the back of the FC-USB in the J1 port...
- Page 2 Place the retaining washers at the designated location on the cooling plate and seat the FC- USB on-top of them. Then fasten the 2x Phillips screws The cooling plate should be supplied with the product's packaging or already assembled. Place the red module spacer in the designated location then place the M.2 storage component side facing...
- Page 3 Assemble the cooling plate with the components installed as a whole unit to the M.2 connectors Fasten the cooling plate in place assembling the 3x Phillips screws. The 3x Philips screws supplied with the product's packaging or already assembled. Stick the RTC battery in its place...
- Page 4 Before placing the bottom cover, make sure the Kensington lock mechanism is oriented to align with the side panel that has the Kensington lock hole Screw the 4x Phillips enclosure Complete by tightening the screw half way, enough to hold Bring both side panels in place, Phillips enclosure screws all the the bottom cover in-place but not...