Fan; Figure 4-22 Removing The Fan - Toshiba PORTEGE R200 Replacement Procedures

4.15 Fan

4.15 Fan
Removing the Fan
To remove the fan, follow the steps below and refer to Figure 4-22.
1. Peel off the glass tape and disconnect the fan cable from the connector CN8770 on
the system board.
2. Remove the following screws and fan.
•
M2×4C BIND
Installing the Fan
To install the fan, follow the steps below and refer to Figure 4-22.
1. Install the fan and secure it with the following screws.
• M2×4C
2. Connect the fan cable to the connector CN8770 on the system board and stick the
glass tape.
PORTEGE R200 Maintenance Manual (960-519)
M2×4C BIND screw
Fan cable
CN8770

Figure 4-22 Removing the fan

BIND screw
4 Replacement Procedures
x2
M2×4C BIND
x2
[CONFIDENTIAL]
Glass tape
Fan
4-33