4.17 Fan
4.17 Fan
Removing the Fan
The following describes the procedure for removing the fan. (See Figure 4-31.)
1. Turn over the system board.
2. Peel off the glass tape and disconnect the fan cable from the connector CN8781 on
the system board.
3. Turn the system board face up.
4. Remove the following screws and fan.
• M2.5×4.0B
PORTEGE M400 Maintenance Manual (960-541)
FLAT HEAD screw
Fan cable
CN8781
Glass tape
Figure 4-31 Removing the fan
4 Replacement Procedures
×2
Fan
[CONFIDENTIAL]
M2.5x4.0B
FLAT HEAD
4-49