Toshiba PORTEGE R200 Replacement Procedures page 29

4.8 Touch pad
Installing the touch pad
To install the touch pad, follow the steps below and refer to Figure 4-11 and 4-12.
1. Connect the touch pad cable to the connector on the touch pad assembly.
2. Install the touch pad assembly according to the guide and secure it with the
following screws.
• M2×3C
3. Connect the touch pad cable to the connector CN3240 on the system board.
4. Install the touch pad cover while engaging the latches.
PORTEGE R200 Maintenance Manual (960-519)
S-FLAT HEAD screw
4 Replacement Procedures
x2
[CONFIDENTIAL] 4-23